餐桌大圆桌控制器调试 小火锅电磁炉桌价格

桌的上漆着色技术及步骤-

 一般来说桌的上漆着色技术分为两种，底擦漆和修面漆，一件色彩通透明快的老榆木家具都是通过这两种技术来实现的，如果只用修面漆来做的话，那么海南定制除烟电机排行榜桌椅家具的表面不会这么透明有光泽。一般来说，一件家具的漆色美不美观是要通过80%的底擦色来体现，色彩不够部分通过面修色来实现。如果桌全部用面修色来体现的化，会使得整个漆面色彩朦胧，没有通透感和光泽度。

 

 

Generally speaking, there are two types of painting and coloring techniques for tables: bottom coat paint and finishing paint. A piece of transparent and fast colored old elm furniture is achieved through these two techniques. If only finishing paint is used, the surface of Hainan custom smoke removal motor ranking table and chair furniture will not be so transparent and glossy. Generally speaking, the beauty of a piece of furniture's paint color is reflected through 80% of the base color, and the insufficient color is achieved through surface finishing. If the table is fully decorated with surface color, it will make the entire paint surface color hazy, lacking transparency and glossiness.

 

 

 

 

桌下面为大家分析桌的上漆技术及步骤：

Below the table, we will analyze the painting techniques and steps for the table:

1：打磨基层，用从粗到细的砂纸把家具表面打光，磨平磨光，用湿布清扫干净，刷一遍清漆（加入稀释夜，漆膜快干）。

1: Polish the base layer, use sandpaper from coarse to fine to polish the surface of the furniture, smooth and polish it, clean it with a damp cloth, and brush it with a layer of varnish (add dilution overnight, the paint film will dry quickly).

2：满刮一遍腻子，砂纸磨光，木结构工艺缝均应嵌入灰腻子，需要压实，并在干燥后打磨光滑；

2: Apply a full layer of putty, sand it smooth, and embed the gray putty into the wooden structure process joints. It needs to be compacted and polished smooth after drying;

 

 

 

 

 

3：刷二遍清漆，用细砂纸磨光；

3: Brush two coats of varnish and polish with fine sandpaper;

4：刷第三道清漆、再磨光如果希望做出来的漆色通透度高的话就多上一遍漆，然后打蜡、擦亮，注意底擦色采用高透格丽斯加净味松香来施工，擦拭时顺木纹方向擦，并用干净的棉布擦掉素材表面残留的格丽斯。擦完颜色的素材板，在夏季高温下晾干4小时以上，在冬季低温晾干6小时以上。

4: Brush the third coat of varnish and then polish it. If you want to achieve a high transparency of the paint color, apply an additional coat of paint, then wax and polish it. Pay attention to using high transparency Grace and pure rosin to apply the base color. When wiping, wipe along the direction of the wood grain and use a clean cotton cloth to wipe off any remaining Grace on the surface of the material. After wiping the colored material board, air it for more than 4 hours at high temperatures in summer and 6 hours at low temperatures in winter.

海南定制除烟电机排行榜充分晾干的目的是让板材中残留的松香水挥发干净，这样表面涂装油漆后气味就会变低。如果我们没有做好相应的干燥处理，使用这样的木材来制作家具，那么在我们的使用过程中，尤其是在不同地区使用的话，各个地方的空气的含水量不同，会导致家具发生变形，缩短、胀裂等问题。海南定制除烟电机排行榜如果发生这些比较严重的话，家具就会坏掉，或者是比较难好。

 

 

 

 

 

The purpose of fully drying Hainan customized smoke removal motor ranking list is to let the residual pine perfume in the plate volatilize clean, so that the smell will become lower after the surface is painted. If we do not properly dry and use such wood to make furniture, then during our use, especially in different regions, the moisture content of the air in different places will be different, which can cause deformation, shortening, and cracking of the furniture. If these serious issues occur, the furniture will either break down or be difficult to repair.