北京电动餐桌椅批发 落地式机芯控制器配套

 

除厂家中山变频电动餐桌锅设备厂家，很多人都不知道原来实木厂家中山变频电动餐桌锅设备所用的木材都需要蒸煮。小编刚开始见到这个词语时还以为是要吃木材，吓一跳。后面稍微认识一下后，才知道蒸煮的目的。蒸煮的目的是为软化木材，增加木材的可塑性和含水率，以减小刨切时的切削阻力，并除去一部分木材中的油脂及单宁等浸提物。一般木方的蒸煮都采用水煮的方式．蒸煮的温度及时间要根据树种及木材的硬度，刨切薄木的厚度进行控制，硬度大的则温度较高，木材厚则蒸煮时间较长。

Except for the manufacturer of Zhongshan variable frequency electric北京电动餐桌椅批发 落地式机芯控制器配套dining table pot equipment, many people are unaware that the wood used in the original solid wood manufacturer's Zhongshan variable frequency electric dining table pot equipment needs to be steamed. When the editor first saw this word, he thought it was about eating wood and was startled. After getting to know each other a little later, I realized the purpose of cooking. The purpose of steaming is to soften wood, increase its plasticity and moisture content, reduce cutting resistance during planing, and remove some of the oil and tannin extracts from the wood. Generally, the cooking of wooden cubes is done by boiling with water. The temperature and time of cooking should be controlled based on the hardness of the tree species and wood, as well as the thickness of the sliced wood. The harder the wood, the higher the temperature, and the thicker the wood, the longer the cooking time.

厂家中山变频电动餐桌锅设备木材干燥指用人工方法强制对木材中的水分蒸发逸散，使木材的含水率降至符合使用要求的含水率，避免湿材在贮存、运输和使用的过程中受虫菌的侵蚀和木材劈裂、变形，提高木材制品的质量，延长使用寿命。木材干燥方法系一种利用气体对流的干燥法。人工干燥方法中重要的有对流加热和电介质加热：前者有窑干、太阳能干燥及离心力干燥；后者有微波干燥、高频干燥。还有辐射加热的红外线干燥法和属于接触加热的接触干燥法。




 

The manufacturer's Zhongshan variable frequency electric dining table pot equipment for wood drying refers to the use of manual methods to forcibly evaporate and dissipate moisture in the wood, reducing the moisture content of the wood to the required moisture content fo北京电动餐桌椅批发 落地式机芯控制器配套r use, avoiding the erosion of insects and fungi, as well as wood splitting and deformation during storage, transportation, and use, improving the quality of wood products and extending their service life. The wood drying method is a drying method that utilizes gas convection. The important methods of artificial drying include convective heating and dielectric heating: the former includes kiln drying, solar drying, and centrifugal force drying; The latter includes microwave drying and high-frequency drying. There are also infrared drying methods using radiation heating and contact drying methods that belong to contact heating.

目前国内外厂家定制蜀味老火锅批发零售均以对流加热的气干和窑干为主，te别是窑干为主要的方法。木材干燥时首先是木材表面的水分蒸发，表层的含水率低于木材内部，内部的水分在含水率梯度的作用下向表层移动。干燥初期的速度取决于木材表层水分蒸发的速度，干北京电动餐桌椅批发 落地式机芯控制器配套燥的中期和后期，干燥速度取决于木材内部水分的移动速度，与板材厚度和木材比重成反比。

At present, domestic and foreign manufacturers mainly use convection heating air drying and kiln drying for the wholesale and retail of customized Sichuan style old hot pot, with kiln drying being the main method. When wood is dried, the water on the surface evaporates first, and the moisture content on the surface is lower than that inside the wood. The internal moisture moves towards the surface under the gradient of moisture content. The speed of drying in the early stage depends on the rate of evaporation of moisture on the surface of the wood. In the middle and late stages of drying, the drying speed depends on the speed of movement of moisture inside the wood, which is inversely proportional to the thickness of the board and the specific gravity of the wood.

另外，厂家定制蜀味老火锅批发零售边材干燥速度比心材快。阔叶树材的弦面板干燥比径面板快；但针叶树材弦径面差异不很明显。有人说成立一家厂家中山变频电动餐桌锅设备子厂家表面看很容易，实际上太难太难，厂家定制蜀味老火锅批发零售仅仅实木这一块都有许多我们讲不清道不明的工序，别说还有其他材质不同款式的厂家中山变频电动餐桌锅设备。

In addition, the manufacturer customizes Shu style old hot pot wholesale and retail with faster drying speed for side materials than heartwood. The drying speed of the chord panel of hardwood is faster than that of the diameter panel; However, the difference in chord d北京电动餐桌椅批发 落地式机芯控制器配套iameter surface of coniferous trees is not very significant. Some people say that establishing a subsidiary manufacturer of Zhongshan variable frequency electric table pot equipment may seem easy on the surface, but in reality, it is too difficult and difficult. The wholesale and retail of customized Sichuan style old hot pot by the manufacturer only involves solid wood, which has many unclear processes. Let alone other manufacturers of Zhongshan variable frequency electric table pot equipment with different materials and styles.