方形餐桌 圆形餐桌 电动桌修复电动桌翻新技巧

方形餐桌 圆形餐桌  电动桌修复电动桌翻新技巧

Solid wood electric table electric table repair electric table renovation skills

 

 

1、实木电动桌电动桌翻新方法：一般在实木电动桌电动桌翻新前，很多处电动桌都会存在着严重的刮痕、开裂等现象，因此需要将其进行处理；然后将实木电动桌电动桌表面清洁干净再进行打磨，打磨可采用专门的电动桌实木电动桌电动桌翻新打磨机器，其目的是为了刮掉木电动桌上的漆；

1. Renovation method for solid wood electric table: Generally, before renovating a solid wood electric table, there will be serious scratches, cracks, and other phenomena in many parts of the electric table, so it needs to be treated; Then clean the surface of the solid wood electric table and polish it. The polishing can be done using a specialized electric table renovation and polishing machine, which aims to scrape off the paint on the wooden electric table;

 

接下来调配好腻子，并均匀的涂抹在实木电动桌电动桌上，并将其风干；电动桌上的腻子风干后便可以进行上漆、上油和打蜡了，等到油漆干燥后，实木电动桌电动桌翻新也就算完成了。

Next, prepare the putty and evenly apply it to the solid wood electric table, then air dry it; After the putty on the electric table dries, it can be painted, oiled, and waxed. After the paint dries, the renovation of the solid wood electric table is considered complete.

 

2、实木电动桌电动桌翻新技巧：在对实木电动桌电动桌进行打磨后需要观察电动桌的平整度，如果有明显的凹凸处，则需要重新打磨平整，打磨的厚度在0.5毫米左右适宜；其次是很多墙角处用打磨机器是不能够打磨到的。

2. Renovation technique for solid wood electric table: After polishing the solid wood electric table, it is necessary to observe the flatness of the electric table. If there are obvious concave and convex areas, it needs to be re polished to a suitable thickness of about 0.5 millimeters; Secondly, many corners cannot be polished with a polishing machine.

 

 

 

因此需要用砂纸进行手动打磨，这样才能够保证打磨的效果，而打磨的方法好是先用粗砂纸打磨，再使用细砂纸，从四个方向逐一进行；

Therefore, it is necessary to manually polish with sandpaper to ensure the polishing effect. The best polishing method is to first use coarse sandpaper to polish, and then use fine sandpaper to polish from four directions one by one;

 

实木电动桌电动桌翻新后的打蜡和上油十分的重要，这能够提高实木电动桌电动桌的使用寿命和光泽，因此在腻子风干后应按照上油漆、上油、打蜡的顺序进行。

Waxing and oiling are very important for refurbished solid wood electric tables, as they can improve their service life and gloss. Therefore, after the putty is air dried, it should be done in the order of painting, oiling, and waxing.